MonthJanuary 2017

Cooling with compressed air

Just a short post on the current state of compressed air cooling.

I am currently testing the Merlin extruder, i decided to name it in the same way as the hotend since the two belong together, which uses compressed air from an aquarium membrane pump (bubble pump). A medium size pump is sufficient for one hotend and one part cooler.

I made the mistake of ordering a larger pump than needed, which makes the printer unnecessarily loud due to to much air hissing out of the small gaps. On the up side, i might be able to push the Merlin hotend beyond 260°C with this. 🙂

 

Compressed air part cooler

Merlin Extruder with compressed air hotend and part cooling

Merlin Extruder with compressed air hotend and part cooling

Merlin extruder with compressed air cooling

 

 

Dual material file heft

This is something i wanted to do for a while. A handle, in this case a file heft, that is a mix of soft but tough material on the outside and hard plastic on the inside.

Like the bottle cap it’s ABS with TPU, but this time the ABS is the bulk of the piece. There are 2 perimeter shells of TPU around a 50% ABS hexagonal infill.

The heft weighs just 24 g, but is very stable with a smooth and grip friendly surface.

You can see the ABS infill structure through the transparent TPU perimeter

Assembled file

Dual material bottle caps

After some terrible experience with TPE i tried TPU. What a difference!

TPU prints super easy and gives you high quality surfaces and it is super tough.

Today my wife needed a new cap for an expensive cleaner, so i took 10 minutes to model one in C4D and printed it in TPU. The first print worked immediately, but i wanted to try something new. I set the TPU up together with ABS and printed the cap with ABS for the infill and TPU for the perimeter.

The result is very much  worth the extra effort. The TPU gives a nice finishe and due to it’s elasticity it seals the bottle very nicely. The ABS gives the extra bit of stiffness so the cap does not deform so easily.

Next up is a file heft made up in the same way.

Printed bottlecaps as replacement

 

 

 

 

 

 

 

 

 

 

SainSmart TPU on Amazon

© 2017 Bonkers

Theme by Anders NorénUp ↑