Share on FacebookShare on Google+Tweet about this on Twitter

mat_Nylon618 01Filament Diameter: 1.78 mm
Nozzle Diameter (Set): 0.2 mm
Nozzle Diameter (Used): 0.2 mm
Nozzle Temperature: 245
Bed Temperature: 100
Bed Surface: Thermoplast (Warp)
Layerheight: 0.2 mm
Infill: 100%
Perimeter speed: 20 mm/s
Infill speed: 60 mm/s
Retract: 3 mm

I have a really hard time getting the Nylon to stick to anything. So far it only stuck on a piece of thermoplast i had laying around, but the plate gets damaged when printing and the Nylon isn’t sticking very good and warping as you can see on the image.
Later i got better results using gluestick (PVA glue) on Glas, for bigger prints this remains a problem though. I found that Whale Tufnol sticks extremely good, unfortunately so good that you can’t remove the part without damaging it.